Revision as of 11:51, 3 April 2016

VFD Wiring Diagram

Huangyang VFD

Huanyang VFD Manual

To change settings:

1. Press [PROGRAM]
2. Use arrow keys to change to program number your looking to change
3. Press [SET]
4. Use the arrow keys to change the value to appropriate value
5. Press [SET] to save the value

Setting needed for galaxy series machines:

• PD001 – Source of Run Command – 0
• PD002 – Source of Operating Frequency – 1
• PD014 - Acceleration - 3
• PD070 – Analog Input 0-10V – 0
• PD144 – Rated Motor Revolution – 3000

Displaying RPM instead of Hz:

Press the arrow over key until the Rott light is illuminated

Sunfar VFD

Sunfar VFD Manual

To change settings:

1. Press [SET]
2. Use arrow keys to change to program number your looking to change
3. Press [SET]
4. Use the arrow keys to change the value to appropriate value
5. Press [SET] to save the value
6. Press [ESC] to exit programming mode

Running:low noise runningF0.0 = 4 (or 3 if you want to test using the knob on the VFD) F1.7=1 F0.2=1001 (or 1000 if you want to test using the knob on VFD) F1.8=2 F0.4= 400 or 1000 set according your spindle F1.9=3 F0.5=10 F0.6=10 F0.11=0 F0.12=400 or 1000 set according your spindle F0.13=220 F1.3=400 or 1000 set according your spindle - See more at: http://www.automationtechnologiesinc.com/products-page/cnc-spindle/kl-vfd03-300w-mini-type-integrated-universal-inverter-vfd#sthash.scilFXlD.dpuf