Difference between revisions of "Vectric"

Revision as of 09:17, 21 November 2014

Information:

Post Processors:

The zip file contains the post processor for use with LinuxCNC. A post is provided for Inch units.

After you unzip the file, the folder will contain the post processor for use with Cut2D, and Vcarve PRO. You will place these in the PostP folder under the Vectric program folder or wherever Vectric stores the post processors. To find that directory see this link: http://support.vectric.com/aspire-questions/item/where-to-find-post-processors-folder-on-pc

Then restart Vectric.

When you restart software the added post will be available as a machine language option. The post processor option for LinuxCNC will typically include G64, or EMC (which used to be LinuxCNC) and the measure system in use (std/metric or in/mm)

@@ Line 2: / Line 2: @@
 == Post Processors: ==
-The zip file contains the post processor for use with LinuxCNC. A post is provided for Inch units. After you unzip the file, the folder will contain the post processor for use with Cut2D, and Vcarve PRO. You will place these in the PostP folder under the Vectric program folder. http://support.vectric.com/aspire-questions/item/where-to-find-post-processors-folder-on-pc
+The zip file contains the post processor for use with LinuxCNC. A post is provided for Inch units.
+[[file:LinuxCNC_Arc_Inch.zip]]
-When you restart software the added post will be available as a machine language option.
+After you unzip the file, the folder will contain the post processor for use with Cut2D, and Vcarve PRO. You will place these in the PostP folder under the Vectric program folder or wherever Vectric stores the post processors. To find that directory see this link: http://support.vectric.com/aspire-questions/item/where-to-find-post-processors-folder-on-pc
-The post processor option for LinuxCNC will typically include G64, or EMC (which used to be LinuxCNC) and the measure system in use (std/metric or in/mm)
+Then restart Vectric.
-[[file:LinuxCNC_Arc_Inch.zip]]
+When you restart software the added post will be available as a machine language option. The post processor option for LinuxCNC will typically include G64, or EMC (which used to be LinuxCNC) and the measure system in use (std/metric or in/mm)