Difference between revisions of "MondoStep 5.6"
From PROBOTIX :: wiki
m |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | [[Category:Need Pictures]] | |
| + | [[Category:Stepper Motor Drivers]] | ||
| + | [[Image:MondoStep4.2_large.jpg|thumb|300px|MondoStep 5.6]] | ||
| + | |||
| + | |||
| + | == Bi-polar Stepper Motor Chopper Driver == | ||
| + | * High performance, cost-effective | ||
| + | * Supply voltage up to +50VDC | ||
| + | * Output current up to 5.6A | ||
| + | * Pure-sinusoidal current control technology | ||
| + | * Pulse input frequency up to 300 KHz | ||
| + | * TTL compatible and optically isolated input | ||
| + | * Automatic idle-current reduction | ||
| + | * 15 selectable resolutions, up to 25600 steps/rev | ||
| + | * Step/Direction and CW/CCW modes | ||
| + | * Short-circuit, over-voltage, over-current and over temperature protection | ||
| + | |||
| + | ==User Manual== | ||
| + | http://www.probotix.com/manuals/MondoStep4.2.pdf | ||
| + | |||
| + | ==Wiring to Motor== | ||
| + | [[file:MondoWiring.jpg]] | ||
| + | ==Motor Wiring to XLR== | ||
| + | [[file:BipolarWire.jpg]] | ||
Latest revision as of 11:45, 14 February 2019
Contents
Bi-polar Stepper Motor Chopper Driver
- High performance, cost-effective
- Supply voltage up to +50VDC
- Output current up to 5.6A
- Pure-sinusoidal current control technology
- Pulse input frequency up to 300 KHz
- TTL compatible and optically isolated input
- Automatic idle-current reduction
- 15 selectable resolutions, up to 25600 steps/rev
- Step/Direction and CW/CCW modes
- Short-circuit, over-voltage, over-current and over temperature protection
User Manual
http://www.probotix.com/manuals/MondoStep4.2.pdf
Wiring to Motor
Motor Wiring to XLR
