Difference between revisions of "Spoil Boards"
From PROBOTIX :: wiki
m (→Un-installing/Installing the Spoilboard) |
|||
| (4 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
==Making a New Spoil Board== | ==Making a New Spoil Board== | ||
| − | [[File:ALL SPOILS.dxf]] | + | The below file can be used for cutting your own spoil board sized for Probotix machines. All necessary mounting holes are present so any material you cut may be used as a drop-in replacement. |
| + | * [[File:ALL SPOILS.dxf]] | ||
| + | == G-Code Files == | ||
| + | * [[G-Code Files]] | ||
| + | You may also want to use our sample files for cutting a grid on the new spoil board | ||
| − | == | + | == Installing/Removing the Spoilboard== |
| + | [[Image:Spoil_board_helper_studs.jpg|thumb|Use studs to help spoilboard placement]] | ||
It helps to use M5 studs to hold the t-nuts in during removal or reinstallation of the spoil board. You can cut the heads off of longer M5 screws, if you cannot find M5 studs. The studs will also work as alignment pins during reinstallation. | It helps to use M5 studs to hold the t-nuts in during removal or reinstallation of the spoil board. You can cut the heads off of longer M5 screws, if you cannot find M5 studs. The studs will also work as alignment pins during reinstallation. | ||
| − | |||
Latest revision as of 17:49, 31 July 2018
Making a New Spoil Board
The below file can be used for cutting your own spoil board sized for Probotix machines. All necessary mounting holes are present so any material you cut may be used as a drop-in replacement.
G-Code Files
You may also want to use our sample files for cutting a grid on the new spoil board
Installing/Removing the Spoilboard
It helps to use M5 studs to hold the t-nuts in during removal or reinstallation of the spoil board. You can cut the heads off of longer M5 screws, if you cannot find M5 studs. The studs will also work as alignment pins during reinstallation.