Latest revision as of 06:56, 23 August 2019

Unity-M Controller

Unity Controller customized for use with bench-top mill conversions using a higher amp Z driver with NEMA34 motor options.

• Expandable to your needs, versatile, and flexible.
• Can be used for 2, 3, or 4 axis systems.
• Get it with or without motors
• Motors (if purchased) are pre-wired with 6 Feet of 5-Conductor 22 Gauge Motor Wire and XLR connectors

Have A Look Inside:

• 40Volt (110VAC Input) Linear Power Supply for the fastest motor operation
• Professionally wired, installed, mounted and tested electronics
• 4 Drivers, Breakout Board, IDC cables, and wired connector ports
• Full Enclosure with Power switch, fan, and fuses
• Modular and organized

Driver System:

• 3x 5.6Amp MondoStep Bipolar Drivers (X, Y, and A axis)
• 1x 7.8Amp MondoStep BiPolar Driver (Z axis)

Breakout Board:

The PBX-MX is an isolated parallel port breakout board for use with software such as LinuxCNC or Mach3.

Integrated back panel includes:

• Connections for up to 4 motors
• Connector for limit switches
• Connector for E-Stop
• Earth ground connection for improved EMI protection
• Auxilary 5v logic output that can drive an accessory like the Powerswitch Tail
• IEC power connections for the primary power and the router control relay
• PBX-MX Isolated Parallel Port breakout board
• Two AC inputs
• Color coded

Pin-Out

	1) A Dir	10) X Limit
	2) X Step	11) Y Limit
	3) X Dir	12) NC
	4) Y Step	13) Z Limit
	5) Y Dir	14) 120VAC Relay
	6) Z Step	15) E-stop
	7) Z Dir	16) 5VDC AUX
	8) NC	17) A Step
	9) NC	18-25) GND

ESTOP	1) Pin 15
	2) GND

LIMITS	1) X Limit (Pin 10)
	2) GND
	3) Y Limit (Pin 11)
	4) GND
	5) NC (Pin 12)
	6) GND
	7) Z Limit (Pin 13)
	8) GND

MOTOR	1) B-
	2) B+
	3) NC
	4) A+
	5) A-