Difference between revisions of "Spoil Boards"
From PROBOTIX :: wiki
m (→Making a New Spoil Board) |
|||
| Line 2: | Line 2: | ||
* [[File:ALL SPOILS.dxf]] | * [[File:ALL SPOILS.dxf]] | ||
The above file can be used for cutting your own spoil board sized for Probotix machines. | The above file can be used for cutting your own spoil board sized for Probotix machines. | ||
| + | |||
| + | == G-Code Files == | ||
| + | * [[G-Code Files]] | ||
| + | You may also want to use our sample files for cutting a grid on the new spoil board | ||
==Un-installing/Installing the Spoilboard== | ==Un-installing/Installing the Spoilboard== | ||
[[Image:Spoil_board_helper_studs.jpg|200px|thumb|Use studs to help spoilboard replacement]] | [[Image:Spoil_board_helper_studs.jpg|200px|thumb|Use studs to help spoilboard replacement]] | ||
It helps to use M5 studs to hold the t-nuts in during removal or reinstallation of the spoil board. You can cut the heads off of longer M5 screws, if you cannot find M5 studs. The studs will also work as alignment pins during reinstallation. | It helps to use M5 studs to hold the t-nuts in during removal or reinstallation of the spoil board. You can cut the heads off of longer M5 screws, if you cannot find M5 studs. The studs will also work as alignment pins during reinstallation. | ||
Revision as of 10:01, 12 June 2018
Making a New Spoil Board
The above file can be used for cutting your own spoil board sized for Probotix machines.
G-Code Files
You may also want to use our sample files for cutting a grid on the new spoil board
Un-installing/Installing the Spoilboard
It helps to use M5 studs to hold the t-nuts in during removal or reinstallation of the spoil board. You can cut the heads off of longer M5 screws, if you cannot find M5 studs. The studs will also work as alignment pins during reinstallation.