Revision as of 12:02, 3 April 2016

VFD Wiring Diagram

Huangyang VFD

Huanyang VFD Manual

To change settings:

1. Press [PROGRAM]
2. Use arrow keys to change to program number your looking to change
3. Press [SET]
4. Use the arrow keys to change the value to appropriate value
5. Press [SET] to save the value

Setting needed for galaxy series machines:

• PD001 – Source of Run Command – 0
• PD002 – Source of Operating Frequency – 1
• PD014 - Acceleration - 3
• PD070 – Analog Input 0-10V – 0
• PD144 – Rated Motor Revolution – 3000

Displaying RPM instead of Hz:

Press the arrow over key until the Rott light is illuminated

Sunfar VFD

Sunfar VFD Manual

To change settings:

1. Press [SET]
2. Use arrow keys to change to program number your looking to change
3. Press [SET]
4. Use the arrow keys to change the value to appropriate value
5. Press [SET] to save the value
6. Press [ESC] to exit programming mode

Setting needed for galaxy series machines:

• F0.0 = 1 (for 0-10V Control) or 3 (for knob control)

  F0.2 = 1001 (for 0-10V Control) /1000 (for knob control)

  F0.5 = 3 (Acceleration time)

  F0.6 = 0 (Deceleration time)

  F0.13 = 220 (Volts)

F1.3=400 or 1000 set according your spindle F1.7=1 F1.8=2 F0.4= 400 or 1000 set according your spindle F1.9=3

F0.12=400 or 1000 set according your spindle